Description; Introduction - Compaq Cabinet H9A11 Installation & Owners Manual

1.1 Description

The H9A11 Cabinet (Figure 1-1) is a low-cost, computer-equipment enclosure system that
meets the Electronic Industries Association (EIA) standard 310C and the International
Electrotechnical Commission (IEC) 297 standards and can accommodate fixed or slide-
mounted chassis that fit into a standard 48.26-cm (19-in.) rack.
The cabinet has the following factory installed features:
Equipment mounting rails with the EIA universal rail-hole pattern
Front trim kit that provides a finished look to the front opening of the cabinet
Vented rear lift-off door
Nonvented top cover
Four nonlocking casters that facilitate the placement of the cabinet. The front two
casters swivel. The rear two casters are fixed.
Adjustable leveling feet that are used to stabilize and secure the cabinet at the
installation site.
Stabilizer bar that is used to provide cabinet stability when installing or sliding
equipment out of the cabinet.
A single-phase H7600-AA (120 Vac), H7600-AB (240 Vac), or H7600-DB (240 Vac)
power distribution units (PDU) --- Each H7600-AA/AB power distribution unit
provides ten (10) ac power outlets and each H7600-DB power distribution unit provides
twelve (12) ac power outlets.

Introduction

H9A11 Cabinet Installation/Owner's Guide 1–1
1