6-1 Installing Disk Drives; 5.25" Disk Drives; Figure 6-1: Installing A 5.25" Disk Drive - Datatech Enterprises Apex 386SX/20 User Manual

6-1 Installing Disk Drives

Three 5.25" floppy/hard disk drives and two 3.5" floppy/hard disk drives
may be installed in the system unit. Installation of a hard disk is
essentially the same as that for a floppy disk.
You may at sometime want to add to or exchange your floppy or hard
disk drives. Follow the instructions below to do so.
Be certain to refer to the manuals for both the disk drive and the
controller card for any additional specific information regarding them
that may be of importance.

5.25" Disk Drives

To install or remove 5.25" disk drives, follow the steps below:

Figure 6-1: Installing a 5.25" Disk Drive

2 Chapter 6: Appendix
• Open the system unit case as described on Figure 2-16.
• Screw the metal guides to the disk drive as shown below:
Slide the back end of the disk drive first into the disk drive
bay.