Figure 3-1: Initial Screen - Datatech Enterprises Apex 386SX/20 User Manual

2. Pressing <ESC> to Enter the Setup Program
If you want to set up special functions provided by BIOS or reconfigure
your system, you will need to enter the setup program. After starting
your computer, press the <Esc> key quickly before the RAM test
finishes. If you miss the chance to do so, reset your system and repeat
the above procedures to enter the setup program. Before the setup
program appears, the following message will appear on the screen:
S E T U P u t i l i t y w i l l b e s t a r t i n g
When the system self test is completed, the setup program will take
over.
Once you have entered the setup program, you will see the following
initial screen:
ROM SETUP PROGRAM VERSION 2.0
(C) COPYRIGHT DATATECH ENTERPRISES CO., LTD 1990.
ALL RIGHTS RESERVED.
1. SET UP SYSTEM CONFIGURATION.
2. PREFORMAT HARD DISK.
3. SET UP BUILT-IN UTILITY.
4. SET UP PASSWORD.
5. SET UP USER-DEFINED HARD DISK TYPE.
6. SET UP NEAT CHIP SET.
9. QUIT SETUP PROGRAM.
CHOOSE ITEM NUMBER : [1]

Figure 3-1: Initial Screen

Chapter 3: Operating Your System
13