Coprocessor Option (Jumper J11)
J11 is used to enable or disable the coprocessor.
Keyboard Connector (Jumper 513)
This connector is located at the back of your system unit. Any AT-com-
patible keyboard with a 5-pin DIN connector may be used. The pin
assignments for keyboard connector J13 are as follows:
Power Supply Connector (Jumper 514)
This connector is provided for the power supply. It is important that this
connector be correctly connected; if not, the mainboard may be
damaged. Information on connecting your power supply may be found
in the Connection to Power Supply section.
1 Keyboard CI
4 Ground
Chapter 2: Setting Up Your System
ck
O
13