Total 32-Bit Memory Switch Settings; Figure 2-5: The Four-Switch Dip Sw1 - DTK Computer Apex 386/40 User Manual

Total 32-bit Memory Switch Settings

The location of the four-switch DIP SW1 can be. seen below. Each
switch has an ON and OFF position (usually the ON position is labeled,
the OFF position is not). SW1 should be set appropriately, based on
the following illustration.
Note:
a
Chapter 2: Setting Up Your System
Side View

Figure 2-5: The Four-switch DIP SW1

• The switch setting for the onboard 32-bit memory must cor-
respond to the physical memory installed onboard.
• The switch setting of the PEI307 must correspond to the
physical memory installed on the card.
• If you don't have a 16-bit memory extension card, the switch
setting for total 32-bit memory must be for an amount larger
than or equal to total installed memory (including onboard
32bit memory and 32-bit memory on the PEI-307).
For example, if the total memory installed is 12MB (8MB
onboard and 4MB on the PEI-307), the switch setting for total
32-bit memory could be 12MB or 16MB.
Top View