Advertisement
Unplug AC, wait 15 seconds reconnect, then press & hold
To toggle between Service Mode tests, press
During each of the modes, pressing
Mode
Model Display
Software Version
EEProm test
Error codes
User Interface
Inlet Temp Test
Outlet Temp Test
Door Switch Test
Sensor Rods Test
Drum Motor Test
Inner Heater/Gas Valve Test
Outer Heater Test
88
GE CONFIDENTIAL AND PROPREITARY INFORMATION - NOT FOR PUBLIC DISCLOSURE
Copyright 2005 General Electric Company
2/1/05
Profile Stainless Steel Dryer
SERVICE MODE:
To exit tests either press STOP, unplug dryer, or wait 30 minutes.
Default Display
SrE or SrG or JrE or JrG
3 digit software version #
see Dryer Error code table*
All LED's & LCD illuminated
Int - LO<95, OPn>275
Out - LO<80, OPn>160
CLS or OPn
R50 (touch rods voltage changes)
iOn or iOF/GOn or GOF
POWER & START
CUSTOM 2
START
will change display or function per below.
EEP
dOF or dOn
oOn or oOF
(SG31)
buttons to enter diagnostic.
for forward or
CUSTOM 1
Press
model selector plug #
E & 2 digit EEProm #
reprograms EEProm from flash
clears fault log
toggles checkerboard on LCD
motor/heater activated to increase temp
motor/heater activated to increase temp
motor activates
motor/heater or ignitor activates
motor/heater activates
for reverse.
START
Advertisement
