Compaq 64-Bit Installation Manual page 24

This chapter outlines the driver installation steps for a Windows NT 4.0 or
later operating system. If you are setting up a new system with Windows NT,
use the RA4100 SAN Solution Support Software CD to install the drivers
necessary to support the 64-Bit/66-MHz Fibre Channel Host Adapter.
NOTE: To install the drivers from the RA4100 SAN Solution Support Software CD, follow
the instructions found inside the CD-ROM sleeve.
NOTE: Compaq SmartStart and Support Software CD with a higher revision number than
the RA4100 SAN Solution Support Software may contain an updated version of RA4100
SAN Solution software. If the SmartStart and Support Software CD is used to install your
operating system software, all required software, including device drivers, will be
automatically installed and configured.
Before installing the drivers, you must:
I
Update your system firmware by running System ROMPaq (see
Chapter 2).
I
Configure the hardware by running the System Configuration Utility.
Installing the Driver
Installing the Drivers
Follow the instructions in this section to install the initial driver manually for a
new 64-Bit/66-MHz Fibre Channel Host Adapter installation or to upgrade the
Installing Drivers for Microsoft
4
Chapter
Windows NT