2. INSTALLATION . Find fuse box in car (fuse the position differs among different vehicle brands). Consult vehicle user manual for placement. . Open fuse box cover plate, measure the placement for wiring from fusebox to powered product. . Plug in USB power device...
Page 4
2. INSTALLATION CONT..Locate a ground point near the fuse box. There is usually either an obvious labeled ground point or a nut / bolt that connects directly to chassis. . Decide whether you want your device wired to a switched Mini Blade or unswitched fuse.
Page 5
2. INSTALLATION CONT... NOTE: This hardwire kit uses easy to put together bullet connectors. Attach each end of bullet connector until you feel a click. . Pull the fuse, place fuse into the TAP fuse, then re-insert into the available fuse slot.
Page 6
2. INSTALLATION CONT... Information below for Dash Cam installation Vehicle Headliner (A) Pillar . Starting at the USB powered product, tuck power cable into the headliner. Once you get to the (A) pillar, there may be a sufficient gap to place power cable or it may be necessary to remove.
3. SPECIFICATIONS • The hard wire kit can have uninterrupted power for 24 hours if connected to vehicle battery or fuse box. • It can stay powered on when your vehicle is turned off. • With function of auto detect battery voltage and low voltage protecting, it can cut power supply when voltage is too low, make sure the car can start normally.
4. USER SUPPORT If you need assistance setting up or have an issue regarding the use of your Xview product contact Xview Customer Support. Australian Agent TEL: 03 – 8587 8898 FAX: 03 – 8587 8866 Mon-Fri 9am – 5pm AEST Please retain this user guide for future reference.