7. Turn the system board bottom side up with the heat sink grille
facing you.
8. Remove the mylar system board shield
9. Remove the three PM2.0 × 5.0 screws
and heat sink to the system board.
10. Lift the system board straight up
will remain resting on the work surface.
Figure 5-27. Removing the Fan and Heat Sink
Reverse the preceding procedures to install the EMI shield, fan,
and heat sink.
Maintenance and Service Guide
Removal and Replacement Procedures
1
2
. The fan and heat sink
3
(Figure 5-27).
that secure the fan
4
5–33