Electric Trim System - Yamaha FX HO 2019 Owner's/Operator's Manual

TIP:
If the RiDE lever is squeezed while the throttle
lever is squeezed, the watercraft will slow
down, and once stopped, move in reverse.
To shift into neutral from forward:
(1) Release the throttle lever.
(2) Lightly squeeze and release the RiDE le-
ver. The "N" (neutral) shift indicator will
be displayed.
0
13.6V
1 "N" (Neutral position)
TIP:
If the RiDE lever is squeezed continuously,
the reverse gate will move to the reverse po-
sition.
EJU45041

Electric trim system

The electric trim system is a function for
changing the vertical angle of the jet thrust
nozzle to change the trim angle and perfor-
mance characteristics of the watercraft.
MPH
100
%
N
x100
RPM
1
Watercraft operation
This function can be used only for forward
operation of the watercraft.
TIP:
When the watercraft is moving in reverse or

is in neutral, the jet thrust nozzle will auto-
matically change to the neutral trim setting.
When the watercraft is shifted into forward,
the jet thrust nozzle will automatically
change to the selected trim setting.
While the watercraft is in neutral, the

"TRIM/T.D.E." switches control the forward
and reverse operation of the T.D.E. (thrust
direction enhancer). (See page 33 for infor-
mation on the T.D.E.)
The watercraft performance characteristics

according to the trim angle change de-
pending on the operating conditions.
Confirming the trim setting
The trim setting can be confirmed by the trim
setting indicator and trim setting level on the
multifunction information center.
2 1
+2
13.6V
1 Trim setting indicator
2 Trim setting level
To change the trim setting:
(1) Shift into forward.
(2) Push the "TRIM/T.D.E." up switch to in-
crease the trim setting and raise the bow,
or push the "TRIM/T.D.E." down switch
to decrease the trim setting and lower
MPH
100
%
F
x100
RPM
31