Getting Started
Entering Calibration Data into an HP 8702A/B
To install from an external disk drive
If you have an HP 9122-series dual-sided disk drive connected to your
HP 8702A/B, use this procedure to enter the source or receiver's calibration
data.
The following procedure is written specifically for entering source data. If you
are entering data for a receiver, simply substitute the word RECEIVER for SOURCE
and the word RCVR for SRC .
1 Locate the LIF - formatted calibration disk provided with the source.
2 Place the disk in the disk drive.
3 On the HP 8702A/B, press:
PRESET
LOCAL , SYSTEM CONTROLLER
CAL , CAL KITS & STDS , SOURCE [COEFF] , CAL STD: SRC DISK
LOAD SRC DISK , READ FILE TITLES , LOAD <filename> .
1-12