Table of Contents
Advertisement
7.3
Decommissioning and Disposal
Care should be taken when disposing of your ResQLink AIS when it is no longer required. It is recom-
mended to remove the battery from the ResQLink AIS by removing the case bottom. It may also be
necessary to remove the rear case to facilitate removal.
The ResQLink AIS is not user serviceable and opening the case will invalidate
!
the warranty.
Once removed the battery and other components of the product should be disposed of
!
following guidelines and laws applicable within the relevant country.
Do not short circuit, incinerate or recharge the battery.
!
Incorrect handling and disposal of batteries may lead to leakage and explosion.
!
It is the owner's responsibility to inform the National Authority under which the beacon was regis-
tered that the beacon has been decommissioned.
7.4
Transport
When shipping your ResQLink AIS the following guidance and regulations should be followed, but you
are advised to contact your nearest battery replacement centre or ACR Electronics prior to shipping
as regulations may have changed.
•
Always pack your ResQLink AIS securely in a stout cardboard carton. ACR Electronics
advises that you keep the original packaging in case of return for service.
•
For surface transport the ResQLink AIS may be shipped under
•
For air transport the ResQLink AIS should be shipped as category
under
IATA packing instruction 970 section
on an aircraft please contact you airline for advice.
•
Consult the manufacturer's instructions for information on carrying a life jacket in your
luggage on board aircraft.
Safety Data sheets for all ACR Electronics products can be found on the ACR Electronics website:
www.acrartex.com/products/resqlink-ais
12/11/2021
USER MANUAL
II. If you are hand carrying your ResQLink AIS
912S-03765-01.00
Special Provision
188.
UN3091
and packed
23
Advertisement
Table of Contents
