Table of Contents
Advertisement
5.4
Insert the Activation Slider
The ResQLink AIS will turn on during this process. Make sure it is turned off as soon as
!
the Activation Slider is in place by pressing and holding the TEST/OFF Key until the LED
flashes red twice and release.
Use the antenna rewind tool supplied in the box
1.
Place the antenna end cap into the recess
2.
Pass the tool through the hole in the top of the
ResQLink AIS and place over the antenna just behind
the end cap
3.
Rotate the tool anticlockwise until fully wound
Hold the tool keeping the antenna coiled
Do not remove the tool until the slider is in place
4.
Push the Activation Slider into place ensuring the
tape lies flat between the slider and the ResQLink
AIS
5.
Release and remove the rewind tool to allow the
antenna to rest behind the Activation Slider
Ensure the ResQLink AIS is turned off by pressing
!
the TEST/OFF Key for 2 seconds.
Slide the red Arming Slide upwards to lock the
!
Antenna Slider in place.
12/11/2021
USER MANUAL
912S-03765-01.00
19
Advertisement
Table of Contents
