Exchange Method Of Barrier Assy; Peel Off Old Ornamental Ring A - Sony Cyber-shot DSC-P150 Service Manual

2-3. EXCHANGE METHOD OF BARRIER ASSY

Service parts
Part Number
1 3-091-427-01
2 X-3954-476-1
3 3-086-156-31
Tools used
Torque driver
Soldering iron
Weight about 60g
Adhesive (Super X) (Note)
Note: Use adhesive (Super X) or an equivalent article.
Don't use what becomes white after drying like a quick-drying glue.

2-3-1. PEEL OFF OLD ORNAMENTAL RING A

The Ornamental Ring A has adhered to the Barrier Assy strongly and accordingly, use a soldering iron to weaken the adhesive force.
Heat four circled portions with the soldering iron.
Heating temperature is about 300ºC.
Beware of a burn since the entire Ornamental Ring becomes hot.
* As the adhesive force of Ornamental Ring A is considerably large, the forced peeling will damage the group-1 frame.
Insert the tip of tweezers, etc. into a notch of the group-1 frame and prize the ring.
* Take extreme care so as not to damage the coated surface of the group-1 frame.
In case of difficult peeling, heat the ring again with the soldering iron.
If this re-heating failed, it may be advisable that the ring be peeled while heating the portions 1 → 2 → 3 → 4 in the under figure one
by one sequentially.
* Discard the removed Ornamental Ring A.
DSC-P150
Part Name
Ring (A), Ornamental
Barrier Assy
Tapping screw (P2)
4
2
Tip
1
Quantity
1
1
2
3
2-5
1
2
3