Epson WorkForce Pro WP-4540 Start Here page 2

3
S hake each cartridge as shown for about 5 seconds.
4
I nstall each cartridge in the correct slot for its color. Push
each cartridge in until it clicks.
5
C lose the front cover.
T he printer starts priming the ink. This takes about
12 minutes. When the green
flashing, priming is complete.
N ote: The included cartridges prime the printer and print about
1000 black pages/900 color pages. Actual page count will vary.
C aution: Don't turn off the printer or open the cover while it is
priming or you'll waste ink.
6
W hen you see this menu on your product's LCD
screen, do not press any buttons yet. Continue with the
instructions in the following sections to load paper into
your product and install software.
5
Load paper in the cassettes
You can load letter-, A4-, or legal-size plain paper in the
cassettes. For instructions on loading envelopes and special
paper in the rear MP tray, see the online User's Guide.
1
P ull out the desired paper cassette.
power light stops
2
S lide the edge guides outward.
N ote: If loading legal-size paper, extend the cassette as
shown.
3
Insert the paper with the printable side facedown.
N ote: Make sure the paper is loaded against the edge guide
and not sticking out from the end of the cassette.
4
S lide the edge guides against the paper, but not too
tight. Make sure the paper is under the tabs on the edge
guides.
5
G ently insert the paper cassette at the bottom of the
printer.
N ote: The paper may slide forward slightly as you insert the
cassette. This is normal.
6
E xtend the output tray and raise the paper stopper as
shown. (Do not raise the paper stopper for legal-size
paper.)