WorkForce
Pro WP-4533 Series
®
Start Here
Read these instructions before using your product.
1
Unpack
Caution:
Do not open ink cartridge packages until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all tape and protective materials, including the foam and
plastic inside the printer.
2
Turn on
1
Connect the power cord to the back of the printer and to an
electrical outlet.
Caution:
Do not connect to your computer yet.
2
Press the
power button.
*412238200*
*412238200*
3
1
2
3
4
5
French
control panel
6
sticker
7
Note:
4
1
2
3
4
5
Select settings
To select English as your language, press OK.
If you want to change the language, select it and
press OK.
Select your country and press OK.
Select Summer if Daylight Saving Time is in effect
(spring through summer); otherwise, select Winter.
Press OK.
Select the date format and press OK.
Use the numeric keypad to set the date and press OK.
Select 12h (
/
) or 24h and press OK.
AM
PM
Use the numeric keypad to set the time and press OK.
You can change the date and time settings by pressing
Setup, selecting Printer Setup, then selecting Date/Time.
Install ink cartridges
Open the front cover.
Unpack the four ink cartridges.
Shake each cartridge as shown for about 5 seconds.
Install each cartridge in the correct slot for its color. Push
each cartridge in until it clicks.
Close the front cover.
The printer starts priming the ink. This takes about
12 minutes. When you see a confi rmation message on
the product's LCD screen, priming is complete.