Labom FP Series Operating Instructions

Mechanical thermometers

Table of Contents

Download this manual

Mechanical thermometers

with electrical contact device, Type series FPxxxx, FUxxxx

Operating Instructions

1 General Information....................................................................................................... 2

1.1 General Safety Notes .............................................................................................. 2

1.2 Intended Use ........................................................................................................... 2

1.3 Conformity with EU Regulations .............................................................................. 2

1.4 ATEX Approval ........................................................................................................ 2

2 Transportation and Storage .......................................................................................... 2

3 Installation and Commissioning .................................................................................. 2

3.1 Mechanical Installation ............................................................................................ 2

3.2 Options for gas expansion thermometer ................................................................. 3

3.3 Electrical Connection .............................................................................................. 3

3.4 Adjusting of contacts ............................................................................................... 3

4 Operation ........................................................................................................................ 4

4.1 Zero-point correction ............................................................................................... 4

4.2 Maintenance / Service ............................................................................................. 4

5 Disassembly ................................................................................................................... 4



Questions about this device? Hotline +49 (0) 4408 804 - 444

LABOM Mess- und Regeltechnik GmbH Im Gewerbepark 13 27798 Hude Deutschland

Tel.: +49 (0) 4408 804-0 Fax: +49 (0) 4408 804-100 e-mail: info@labom.com www.labom.com

BA_066

Rev 1J6

Page 1/4

Table of Contents

Need help?

Do you have a question about the FP Series and is the answer not in the manual?

Page 1 BA_066 Questions about this device? Hotline +49 (0) 4408 804 - 444 Rev 1J6 LABOM Mess- und Regeltechnik GmbH Im Gewerbepark 13 27798 Hude Deutschland Page 1/4 Tel.: +49 (0) 4408 804-0 Fax: +49 (0) 4408 804-100 e-mail: info@labom.com www.labom.com...
Page 2 In addition to this instruction, be sure to observe all statutory requirements, applicable standards, the additional technical specifications on the accompanying data sheet (see www.labom.com) as well as the specifications indicated on the type plate. General Safety Notes The installation, set up, service or disassembly of this device must only be done by trained, qualified personnel using suitable equipment and authorized to do so.
Page 3 Operating the contact outside of the scale range is not permitted. You can find additional information on contacts in the document TA_039, available on our website at www.labom.com. BA_066 Rev 1J6 Mechanical thermometers Page 3/4...
Page 4 Operation During operation, take care that the device remains within its intended pressure and temperature ranges. No other monitoring is necessary. The permissible ambient and media temperature depends on the type of device and its design. This information can be found in the relevant data sheet. Zero-point correction Small measuring...

Fu series