Color Temperature - Bresser BR SL Series Instruction Manual

power switch on the light is switched off.
2. Press the ON/OFF button on the
remote control once shortly to activate
the remote control.
3. Check that the red status LED on the
remote control is on and that the
dimming function is activated.
4. If the dimming function is not set,
press the MENU button on the remote
control until the red status LED on the
remote control is on. Each time you
press the MENU button on the remote
control, you can switch between the
brightness, color temperature* and
channel settings menu.
5. Set the desired light output by pressing
the [+] or [–] buttons on the remote
ontrol. When a new value is set for the
first time, the values on the light are
automatically synchronized with the
settings of the remote control.
6. The brightness of the light changes
and the selected values for the
brightness are shown on the displays
of the light and the remote control at
the same time.
• The brightness can be adjusted in
steps of 1% from 10 to 99%.
• The selected values are applied and
saved by the device immediately.
SELECTING COLOR
TEMPERATURE* OR
SPECIAL LIGHT EFFECTS
CONTROL
NOTE: Make sure that the light and
the remote control have been correctly
paired up and the same channels are
set.
1. Shortly press the ON/OFF button to
activate the remote control.
2. Press and hold the MENU button
until the green LED is on. The remote
control will go to the special effect
light control mode.
3. Shortly press the MENU button to
change the brightness or the flash
speed. When both, red and green
*only when used with compatible bicolor lights
LED are on, dimmmer is able to be
changed. When both, orange and
green LED are on, flash speed is able
to be changed. When only the green
LED is on, special light effects are able
to be changed.
5. Long press the MENU button until the
orange LED is on (green LED is off),
the remote controller goes to color
temperature control.

COLOR TEMPERATURE*

NOTE: Make sure that the light and
the remote control have been correctly
paired up and the same channels are set.
1. Shortly press the ON/OFF button to
activate the remote control.
2. Check that the orange status LED
on the remote control is on and that
the color temperature* set mode is
activated.
3. If the color temperature* set mode is
not activated, press the MENU button
on the remote control until the orange
status LED lights up. Each time you
press the MENU button on the remote
control, you can switch between the
brightness, color temperature* and
channel setting menu.
4. The currently set color temperature*
is shown in shortened form on the
display of the remote control. For
example, 32 means 3,200 K, 44 means
4,400 K and 55 means 5,500 K.
5. Set the desired color temperature*
by pressing the [+] or the [–] button
on the remote control. When a new
value is set for the first time, the
values for the light are automatically
synchronised with the settings of the
remote control.
NOTE: The color temperature* can be
set in steps of 100 Kelvin from 3,200 to
5,500 Kelvin.
The selected values are applied and
saved by the device immediately.
SPECIAL LIGHT EFFECTS
NOTE: Make sure that the light and
the remote control have been correctly
paired up and the same channels are set.