Inserting Batteries; Setting Brightness - Bresser BR SL Series Instruction Manual

INSERTING BATTERIES

1. Remove the cover from the battery
compartment on the backside.
2. Insert two batteries into the battery
compartment in the direction of the
printed markings.
3. Re-attach the cover.
4. The remote conbtrol is now ready for use.
SELECTING A CHANNEL
& SYNCHRONIZING
1. Make sure that the light you are able
to work with is switched on.
2. Press the On/Off button on the
remote control shortly to activate the
display.
3. Check the currently selected settings
in the light and the remote control.
The channel selected on the remote
control must be the same as the
channel set on the light.
4. If the channels are incorrectly set,
press the MENU button on the
remote control. Each time you press
the MENU button on the remote
control, you switch between setting
the brightness, colour temperature
and channel.
5. Select channel setting.
6. The currently set channel is displayed
and the channel selection is activated
if no function light lights up on the
remote control display.
7. Set the desired channel by pressing
the plus [+] or minus [-] buttons on
the remote control.
8. Press the MENU button again to
confirm the channel selection and
to return to the settings menu
for brightness adjustment (basic
settings).
9. Then check whether the selected
information matches
remote control and on the device. If
necessary, correct the values on the
light as described in section.
10. The light is now ready to be operated
via the remote control.
11. The display of the remote control has
an automatic switch off function. To
reactivate the display, press the On/
Off button shortly.
12. In the circumstance that the channel of
the remote is set to "00", it can control
all the devices at any channel from 01
to 99 at the same time. The brightness
intensity and color temperature can
be
devices can be switched on or off by
the remote control.
SWITCHING THE LIGHT ON/
OFF & STANDBY STATUS
NOTE: Make sure that the light and
the remote control have been correctly
paired up and the same channels are set.
1. Use the ON/OFF switch to switch on
the light and select the correct power
source (if not already done).
NOTE: The ON/OFF function on the
remote control will not work if the mains
power switch on the lamp is switched off.
2. Press the ON/OFF button on the
remote control once shortly to activate
the remote control.
4. Press the ON/OFF button on the
remote
seconds to switch the lamp off (set
into standby mode.)
5. Press the ON/OFF button on the
remote control shortly again to switch
on the light with the remote control.
6. The remote control has an automatic
switch off function. To reactivate the
display, please press the ON/OFF
button shortly.

SETTING BRIGHTNESS

(DIMMER)
NOTE: Make sure that the light and
the remote control have been correctly
paired up and the same channels are set.
on the
1. Use the ON/OFF switch to switch on
the light and select the correct power
source (if not already done).
NOTE: The ON/OFF function on the
remote control will not work if the mains
increased/decreased
control for
GB
and the
approx. 2-3