Trane X13511542010 User Manual page 9

5. Align the base and mark the location of the two mounting holes on the wall. Install proper side
6. Install anchors in the wall.
7. Insert screws in mounting holes on each side of the base (see the figure below).
Figure 3.
8. Gently swing back the circuit board on the base and push on it until the tabs lock it.
9. Strip each wire 1/4 inch from end.
10. Insert each wire according to wiring diagram.
11. Gently push excess wiring back into hole (see the figure below).
12. Re-install wiring terminals in their correct locations (see the figure below).
13. Re-install the cover (top side first) and gently push extra wire length back into the hole in the
14. Install security screw.
Figure 4.
BAS-SVU10C-EN
of base up.
Location of PCB retaining tabs
wall.
Reinstall terminal blocks
Installation
9