Stihl iMOW 5.0 EVO Instruction Manual page 75

9 Completing the Perimeter Wire Installation
► Insert the perimeter wire (1) into the left con‐
duit (5) and feed it through.
Push the wire end (1) upward inside the docking
station.
► Mark the wire end (1) near the housing using
the matching cable marker (6).
Docking station outside the mowing area
► Route the perimeter wire (1) close to the
already routed perimeter wire and secure with
a fixing pin (2).
3
1
► Route the perimeter wire (1) parallel and
closely to the other perimeter wire for 37 cm
®
(length: 1x iMOW
station without crossing over the perimeter
wires.
► Route the perimeter wire (1) back to the edge
and further toward the base plate (3).
0458-012-9801-A
1
6
2
1
Ruler) back to the docking
4
► Attach the perimeter wire (1) directly on the
base plate (3) with a fixing pin (4).
► Use the perimeter wire (1) to measure two
times the width of the base plate (3) and then
cut the perimeter wire (1) to length with a wire
cutter.
5
1
► Install the perimeter wire (1) in the base plate
so that the guide wire lies flat in the cable duct
and is secured by the hook (5).
6
► Insert the perimeter wire (1) into the left con‐
duit (6) and feed it through.
Push the wire end (1) upward inside the docking
station.
► Mark the wire end (1) near the housing using
the matching cable marker (7).
English
1
3
1
1
7
75