Status Window - Electrolux EIDW6305GS Use And Care Manual

Operating Instructions
8

STATUS WINDOW

AVAILABLE ON EIDW6305
The STATUS window displays codes typically seen
during normal operation or programming of the
dishwasher. The STATUS window indicates the
following activity:
1-24
CL
hd
WASHING
CLEAN
SANITIZED SANITIZED will illuminate on the
Indicates number of delay start
hours for selected cycle.
Flashes once the program has
been entered and the START/
CANCEL key is pressed. It also
flashes if the door is opened during
a wash cycle. Close the
dishwasher door to begin or
continue a wash cycle.
Flashes to indicate a water heat
delay. Time remaining is displayed
in the center of the status window
when a cycle is being ran.
WASHING will be illuminated in the
upper left corner.
CLEAN will illuminate on the left
side of the display after a cycle is
ran and the dishes are clean.
left side of the display after the
cycle. If SANITIZE option was
selected.
Start/Cancel
To start a cycle, press the START/CANCEL key
once and close the door. To cancel when a cycle is
running, open the door and press the START/
CANCEL key once. Close the door again and the
dishwasher will drain and shut off.
NOTE
Opening the door during normal operation will
only pause the selected cycle.
Error Indications
In certain situations which are critical to the ma-
chine function and safe operation, the control shall
shut down and indicate an error code 'Er' (See Error
Codes on page 21). On units without a display, all
indicator lights will flash.
If one of these codes are displayed contact the
Electrolux Customer Care Center at
3287
. They will be able to provide assistance in
troubleshooting the problem and/or locating an
authorized service technician, if needed.
1-877-435-