Headset Controls - Plantronics Voyager B230 Quick Start Manual

Headset controls

1 2
1 Volume/Mute button
Increase/decrease volume
Mute mic during a call
Pause/Play streaming audio
2 Call button
Take a call or end it
Call back last call
Initiate phone's voice-dialing
Reconnect lost connection
3 Micro USB charging port
4 Power button
On or off
Talk time voice alert
Activate pairing mode
5 LED
Charging
Battery status
Pairing mode
4
3 4 5
Tap + or – button per level change
1-second press of both + and – buttons
1-second press of both + and – buttons
1 tap
2 taps
2-second press until tone heard
1 tap
90 minutes for full charge
2-second press
1 tap
With headset off press until LED fl ashes red/blue
Solid red. When fully charged, LED is off.
Low = 2 red fl ashes, Recharge = 3 red fl ashes
Flashes red/blue
Step 1 Set up your headset and computer
Install the software
Download and install the Plantronics software at plantronics.com/software.
NOTE You must be connected to the internet in order to access the software.
Once the software is installed, Windows users can access the utility by
selecting Start > Programs > Plantronics > Plantronics Control Panel.
Charge your headset
To calibrate your headset and provide optimal
performance fully charge the headset before using.
The headset LED will be solid red to indicate that
the headset battery is charging. When fully charged
the LED goes off.
NOTE
To charge the headset with USB charging cable the PC must be on and in
an active state.
charging time
30 min ...........................
.
Minimum charge
before fi rst use
1.5 hours ......................................
d
Full charge
e the PC must be on and in
5