Electrolux EW3LDF65GS Installation Instructions Manual
Electrolux EW3LDF65GS Installation Instructions Manual

Electrolux EW3LDF65GS Installation Instructions Manual

30" dual-fuel freestanding range with wave-touch® controls
Hide thumbs Also See for EW3LDF65GS:

Advertisement

INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL
INSTALLATION AND SERVICE MUST BE
PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL
INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE.
If the information in this
manual is not followed exactly, a fire or
explosion may result causing property
damage, personal injury or death.

FOR YOUR SAFETY:

— Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in your
building.
• Immediately call your gas supplier
from a neighbor's phone. Follow
the gas supplier's instructions.
• If you cannot reach your gas
supplier, call the fire department.
— Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
Clearances and Dimensions
Location: Check location where the range will be
installed. Check for proper electrical and gas supply,
and the stability of the floor.
Dimensions that are shown must be used. Given
dimensions provide minimum clearance. Contact
surface must be solid and level.
Refer to your serial plate for applicable
agency certifications
Provide Proper Fuel Type
Before Proceeding: Your range is preset to operate on L.P.
(Liquified Petroleum) Gas only.
Important Note to the Consumer
• Keep these instructions with your Use & Care Guide for
future reference.
• As when using any appliance generating heat, there are
certain safety precautions you should follow. These are
listed in the Use & Care Guide, read it carefully.
• Be sure your range is installed and grounded properly
by a qualified installer or service technician.
• Make sure the wall coverings around the range can
withstand the heat generated by the range.
• To eliminate the need to reach over the surface
elements or burners, cabinet storage space directly
above the range should be avoided.
Important Notes to the Installer
• Read all instructions contained in these installation
instructions before installing range.
• Remove all packing material from the oven
compartments before connecting the gas and electrical
supply to the range.
• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the consumer.
1

Advertisement

Table of Contents
loading

Summary of Contents for Electrolux EW3LDF65GS

  • Page 1: For Your Safety

    INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
  • Page 2: Important Safety Instructions

    INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL IMPORTANT SAFETY INSTRUCTIONS Installation of this range must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code ANSI Z223.1—latest edition when installed in the United States. When installed in a manufactured (mobile) home, installation must conform with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280...
  • Page 3: Table Of Contents

    INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL Tools you will need (Wear safety glasses when using tools): For leveling legs and Anti-Tip Bracket: • Adjustable wrench or channel lock pliers (Fig. 5). • 1/4" & 5/16" Nutdriver or flat head screwdriver (Fig. 6). •...
  • Page 4 INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5”...
  • Page 5: Fig. 23

    INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL Installation with cabinets and wall Minimum clearance to side wall on either side of range is 5” Fig. D Anti-tip installation IMPORTANT SAFETY WARNING! To reduce the risk of tipping of the range, the range must be secured to the floor by properly installed anti- tip bracket and screws packed with the range.
  • Page 6: Fig. 25

    INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL Anti-tip bracket installation instructions Electrical requirements Fig. 24 Electrical connection requirements This appliance must be properly installed and grounded by a qualified technician in accordance with the National Electrical Code ANSI/NFPA No. 70 -- latest edition -- and local electrical code requirements.
  • Page 7: Fig. 29

    INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL Range installations steps Install the power cord. The rear access cover must be removed. To remove, loosen center screw (one screw) and remove access cover. The terminal block will then be accessible (See Fig. 30). Fig.
  • Page 8: Fig. 33

    INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL Range installation instructions 3-Wire connection instructions (for existing installations ONLY See Fig. 34) Power Cord Connection 1. Follow the manufacturer’s installation instructions supplied with the strain relief and install (Also see Figs. 29, 30 & 31). 2.
  • Page 9: Fig. 36

    INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL Range installations steps 2. (3 & 4 - Wire Permanent Connections) Strip insulation away from the ends of the permanent wiring for Line 1, Line 2, Neutral (also strip ground wire on 4- Wire Connections). Tighten all 3 wire leads to the terminal block (Follow wire locations shown in Fig.
  • Page 10 INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL Range installation instructions Provide an adequate gas supply. This range is pre-set to operate on 4" natural gas manifold pressure. A convertible Pressure Regulator is connected to the manifold and MUST be connected in series with the gas supply line (Refer to Fig.
  • Page 11 INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL Range installations steps Carefully slide range into cabinet opening. Carefully slide range into cabinet opening while inserting rear leveling leg into and FULLY ENGAGING THE ANTI-TIP BRACKET (See Fig. 26). Make sure that the flexible appliance conduit (Fig.
  • Page 12 INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL Range installations steps Test to verify if “LO or LOW” setting should be adjusted (all other positions): 1. Follow steps a thru d above. 2. Insert a thin-bladed screwdriver into the hollow valve stem and engage the slotted screw inside. Flame size can be increased or decreased with the turn of the screw.

Table of Contents