Advertisement
○ Connect OPEN door controller terminal to switch OPEN terminal using new wire
○ Connect motor GND terminal to M_GND door controller
○ Connect motor STOP terminal to STOP door controller terminal
○ Connect motor CLOSE terminal to CLOSE door controller terminal
○ Connect motor OPEN terminal to OPEN door controller terminal
○ Use the second hole on the right side of plate for wire access
○ Close the hangarbot door controller cover
○ Connect all power to the hangar door
○ Connect power to the door controller using the enclosed power adapter
○ Installers may drill additional hole on the right side of the plate, opposite to the
power cord.
5. Housing installation
○ If the hangar walls have metal, mount the door controller using the magnets on
the back of the unit
○ If the hangar walls don't have metal, use the key holes shown below:
Figure 5
6. HangarBot App
○ Add Door controller
■ Door controller and hub needs to be plugged in while pairing the door
controller to hub
■ Add a new device under "DASHBOARD" or "CONTROLS" or MENU
option
■ Type in the device id found on the back of the door controller:
DCN-8000-17-v1
February 2018
www.hangarbot.com
6
Advertisement
