Wiring Installation Steps- For Electrician/Installers - Hangarbot DCN-8000-17-v1 Installation Manual

Figure 4

4. Wiring Installation Steps- For Electrician/Installers

○ Disconnect all power to the hangar door (breaker, relay ..etc)
○ Open the Hangarbot door controller cover
○ Connect M_GND door controller to switch GND terminal using new wire
○ Connect STOP door controller terminal to switch STOP terminal using new wire
(color)
○ Connect CLOSE door controller terminal to switch CLOSE terminal using new
wire
DCN-8000-17-v1
February 2018
www.hangarbot.com
.
5