bouncepad Wing Assembly Instructions

Wing - Slim
Assembly Instructions
Tools Required:
All tools provided
Sheet Code: BP-IM-071_REV1
Release Date: 24/05/2021
Copyright 2016 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Confidential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Minimum:
380mm 15"
or
Position the Mount Bracket on the
1
ground where the stand is to be
located.
Remove the Access Panel from the
4
Mounting Arm. Store all parts safely
aside for use later.
Mounting Arm
Case Back
Mounting Arm
Access Panel
In the Box
*fixings to attach the
product to the ground
are not provided.
Mark your mounting surface, then
2
drill (as appropriate to your chosen
fixing method).
If using a hard-wired power supply,
5
feed the cable into the Mounting
Arm.
Faceplate
Mounting
Bracket
Bouncepad
Lock
*Fitted into Case by Bouncepad.
**Lock available as optional extra
(at additional charge).
*shown for illustrative purposes.
Secure the Mount Bracket to your
3
mounting surface, with your chosen
fixing method.
Locate the Mounting Arm onto the
6
Mount Bracket as shown.
8x M4x8mm
Buttonhead
screw
10x M6x10mm
Buttonhead
screw
*fixings to attach the stand to the
ground are not provided.
Fixings
List