Table of Contents
Advertisement
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended use
The power tool is intended for cutting, roughing and brush-
ing metal and stone materials without the use of water.
A separate protective guard for cutting must be used when
cutting with bonded abrasives.
Sufficient dust extraction must be provided when cutting
stone.
With approved abrasive tools, the power tool can be used for
sanding with sanding discs.
Product features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Spindle lock button
(2) On/off switch
(3) Auxiliary handle (insulated gripping surface)
(4) Grinding spindle
(5) Protective guard for grinding
(6) Locking screw for protective guard
Technical data
Angle Grinder
Article number
Rated power input
Rated speed
Max. grinding disc diameter
Grinding spindle thread
Max. thread length of grinding spindle
Restart protection
Starting current limitation
Weight according to EPTA-Procedure 01/2014
– with low-vibration auxiliary handle
– with standard auxiliary handle
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Notes on mains connection requirements for GWS 20-230 P:
The appliance meets IEC 61000-3-11 requirements and is subject to conditional connection. The appliance can lead to occa-
sional voltage fluctuations under unfavorable power conditions. The impedance of this appliance is set as Z
user must make sure, that the connection point, with the impedance Z
impedance requirement: Z
≥ Z
actual
thority.
Angle Grinder
Article number
Rated power input
Rated speed
Max. grinding disc diameter
Bosch Power Tools
(7) Mounting flange with O‑ring
(8) Grinding disc
(9) Clamping nut
(10) Two-pin spanner for clamping nut
(11) Quick-clamping nut
(12) Carbide grinding head
(13) Protective guard for cutting
(14) Cutting disc
(15) Hand guard
(16) Spacer discs
(17) Rubber sanding pad
(18) Abrasive disc
(19) Round nut
(20) Cup brush
(21) Extraction guard for cutting with cutting guides
(22) Diamond cutting disc
(23) Handle (insulated gripping surface)
a) Accessories shown or described are not included with the
. If Z
is unknown, determine Z
max
max
GWS 22-230 P
3 601 HC1 1..
W
–1
min
mm
a)
a)
a)
a)
a)
a)
a)
a)
a)
a)
a)
product as standard. You can find the complete selection of
accessories in our accessories range.
GWS 20-230 P
3 601 HC1 1..
W
2000
–1
min
6500
mm
230
M 14
mm
25
–
–
kg
5.5
kg
5.4
/ II
, on which the appliance shall be plugged in meets the
max
in consultation with the network supplier or supply au-
max
GWS 22-180 J
3 601 HC0 3..
2200
2200
6500
8500
230
180
1 609 92A 87D | (25.10.2022)
English | 19
a)
a)
GWS 20-230 J
3 601 HC1 3..
2000
6500
230
M 14
25
●
●
5.5
5.4
/ II
= 0.18 Ω. The
actual
GWS 22-230 J
3 601 HC1 3..
2200
6500
230
Advertisement
Table of Contents
