Table of Contents
Advertisement
3. Safety Information
3.1 General Safety Information
Only trained and authorised personnel should be permitted to work on this equipment. It is
assumed that those using this guide are competent to work on equipment of this nature and will
take appropriate precautions when working with the fault analysis guide.
All devices should be inspected upon receipt for signs of physical damage, which may in turn, affect
operational performance, or the overall safety of the unit. Any damaged items should be returned
to Parallax Digital Technologies Ltd for safety checks.
Parallax Digital Technologies accepts no responsibility for any injury or loss caused by unsafe or
inadequate working practices, or for work carried out by an unauthorised third party.
To prevent possible danger, damage, and bodily harm when handling the equipment, please
observe all warnings, cautions notices contained in this section. Failure to heed the following
danger, warnings, and cautionary statements could lead to serious injury or death.
3.2 DC Power Supply
The Unit should be mains-fed using a DC Power Supply using an appropriately rated cable
assembly, which is protected internally at the power supply device itself. If the device is to be fed
from an alternative power source, then the appropriate circuit protection device should be used
to ensure that the supply circuit is interrupted, in the event that a fault in the device causes too
much current to flow into it, causing an unsafe condition.
4. Packing List
The following items are included in the shipping carton:
• 1 x PDT-PIN-7002-MP-I Industrial PoE Injector
• 1 x DIN Rail Mounting Kit (Fitted)
• 1 x Wall Mounting Kit
• Operation & Maintenance Manual (May be electronically supplied)
• Declaration of Conformity (May be electronically supplied)
Advertisement
Table of Contents
