Reset Frame To Factory Default - Riedel MediorNet TDM 7.2 User Manual

2.6.7

Reset Frame to factory default

To delete all settings of a frame and reset the IP address to 169.254.1.1 you need to reset the frame to factory
default values. With a thin tool, for instance a paper clip, you are able to press the button behind a little hole in
the frames.
short push
long push
(more than 4 seconds)
MN-MicroN-UHD
There is a reset button on both the front and
rear side.
Front: between the OLED display and the rotary
encoder.
Rear: at the bottom between the management
connector and the power connector.
MN-MicroN
There is a reset button on both the front and
rear side.
Front: between the FAN LED and PWR LED.
Rear: at the bottom between the config
connector and the power connector.
MN-Compact
The reset button is located on the front side at
the bottom between the right two SYNC OUT
connectors.
MN-MetroN
There is a reset button on both the front and
rear side.
Front: between the FAN 1 and FAN 2 LED.
Rear: between the PSU2 and PSU1 LED.
MN-Modular
The MN-XSS has one reset button on the front
side between the MADI 2 IN and OUT
connectors.
96
All settings in the frame are deleted by resetting a frame.
The IP of the frame is set to 169.254.1.1
restart of the frame (equal to a power cycle)
frame is reset to factory default settings
figure 80: reset button MN-MicroN-UHD (front / rear)
figure 81: reset button MN-MicroN (front / rear)
figure 82: reset button MN-Compact (front)
figure 83: reset button MN-MetroN (front / rear)
figure 84: reset button MN-XSS (front)
MediorNet TDM 7.2 User Manual I00