Advertisement
Operation
Operating Instructions (Controls)- See Figure 5
Icon
1
2
3
4
5
6
User Modes:
Mode Name /Description
Change Celsius (
C) to Fahrenheit
0
(
F)
0
Disable/Enable Heat Options
on product and remote control
Disable/Enable Heat Options
on product only
Optimal Product Setup
When the product is switched on, the default brightness setting is F3, with all the
effects operating. However, for optimal effect if the product is in a bright room, it is
recommended that the top lights are switched off. If the product is operating in a
darker room, it is recommended that the top lights are switched on, and the brightness
effect is changed to Pulsing.
Please note: The product will maintain the most recent brightness settings if switched
to standby. If the product is unplugged at the wall, it will revert to factory setting.
Description
Press Once to turn the product 'ON'.
Press a second time to put the product into 'STANDBY'
(When returning from 'STANDBY' mode the product will return to
previous settings unless the product has been unplugged, in which
case it will reset to factory settings)
'FLAME EFFECT' button this button will cycle through the settings
'F0', 'F1', 'F2', 'F3', 'P'.
Press to turn ON/OFF the Top light illuminating the fuel bed.
'HEAT' switch cycles the unit sequentially through the 4 settings:
LOW HEAT, HIGH HEAT, COOL BLOW and OFF. The heat setting will
be indicated by an icon in the display. See table on previous page
for further details.
Press multiple times to increase the heater temperature in 1
increments. The highest temperature that can be set 31
When High Heat is selected, the letters 'HH' appear in the display,
this means the heat will remain ON continuously and is not
controlled by the thermostat.
Press multiple times to lower the heater temperature in 1
increments. The lowest temperature that can be set is 18
Action (Actions cannot be input by remote control)
Press both Temp down (
until beep is heard and display flashes. (To revert back to Celsius
repeat this action)
Hold both Heat Cycle ( ) and Temp Up ( ), on the product, for 5
seconds, when the heater has been disabled the display will read
"--" and beep 1 time. To enable heat repeat this action.
Hold both Flame cycle (
for 5 seconds, when the heater has been disabled the product will
beep. This will disable heat control functions on the product only. To
enable heat repeat this action. Note: the remote control will still be
able to operate heat functions.
) and Temp up (
) on the unit and hold
) and Heat cycle ( ), on the product,
C
0
C.
0
0
C
C.
0
13
Advertisement
