Oakley THUMP PRO User Manual page 29

U.S. - FEDERAL COMMUNICATIONS COMMISSION (FCC)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modification to this product not authorized by Oakley, Inc could void your authority to operate the product.
This product was tested for EMC compliance under conditions that included the use of Oakley peripheral devices and Oakley
shielded cables and connectors between system components. It is important that you use Oakley peripheral devices and
shielded cables and connectors between system components to reduce the possibility of causing interference to radios,
television sets, and other electronics devices. You can obtain Oakley peripheral devices and the properly shielded cable and
connectors through the Oakley web site at www.oakley.com/mp3 or by calling Oakley at 1 (800) 969-2895 in the United States.
Outside the United States, contact your nearest Oakley Authorized Reseller. For non-Oakley peripheral devices, contact the
manufacturer or dealer for assistance.
RADIO AND TELEVISION INTERFERENCE
This equipment has been tested and found to comply with the limits for a Class B digital device in accordance with the
specifications in Part 15 of FCC rules. These specifications are designed to provide reasonable protection against such
interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation.
This equipment generates, uses, and can radiate radio-frequency energy. If it is not installed and used properly (i.e., in
accordance with Oakley's instructions), it may cause harmful interference to radio communications and television reception.
You can determine whether the product is causing interference by turning it off. In addition, you can try to correct the
interference by using one or more of the following measures:
• Turn the television or radio antenna until the interference stops.
• Move the device to the opposite side of the television or radio.
• Move the device farther away from the television or radio.
• Plug the device into an outlet that is on a different electrical circuit from the television or radio. (That is, make
certain the device and the television or radio are on circuits controlled by different circuit breakers or fuses.)
• Consult Oakley or an experienced radio/TV technician for help
CANADA
This device complies under Industry Canada Guidelines.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Ce matériel est conforme selon les directives des Industries Canadiennes.
Son fonctionnement est sujet aux deux conditions suivantes:
1. Le matériel ne peut être source d'interférences et
2. Doit accepter toutes les interférences reçues, y compris celles pouvant provoquer un fonctionnement indésirable.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
27
THUMP PRO USER GUIDE