Page 1
This quick start guide provides an basic overview of the installation, operation, and diagnostics of the Aparian J1939 Router Series B module. The J1939 Router/B provides intelligent data routing between either EtherNet/IP or Modbus TCP/RTU and a J1939 network. This allows the user to integrate J1939 devices into a Rockwell Automation Logix platform (e.g., ControlLogix or CompactLogix) or any...
Page 2
Revision 1.1 01/2023 REQUIRED SOFTWARE The J1939 Router/B requires Aparian Slate software to setup and configure. The software installation can be found at www.aparian.com/software/slate. MODULE INSTALLATION The module has two Ethernet ports located at the lower front of the module. There are also two ports at the bottom of the module for RS232/RS485 serial and power.
Page 3
Revision 1.1 01/2023 If the LED is red, then the module is not operating correctly. For example, if the module application firmware has been corrupted or there is a hardware fault the module will have a red Module LED. If the LED is green (flashing), then the module has booted and is running correctly without any application configuration loaded.
Page 4
WARNING – Cancer and reproductive harm – www.p65warnings.ca.gov ADDITIONAL INFORMATION The following resources contain additional information that can assist the user with the module installation and operation. Resource Link Slate Installation www.aparian.com/software/slate J1939 Router User Manual https://www.aparian.com/products/j1939Routerb J1939 Router Datasheet www.cisco.com/c/en/us/td/docs/video/cds/cde/cd Ethernet wiring standard e205_220_420/installation/guide/cde205_220_420 _hig/Connectors.html http://www.sae.org/standardsdev/groundvehicle/j...
Need help?
Do you have a question about the J1939/B Series and is the answer not in the manual?
Questions and answers