Initial Ip Configuration - LevelOne ACC-2000 User Manual

1.2 Initial IP configuration

In factory default, DHCP mode is disabled (IP auto configuration = None), and the IP
settings are as below:
IP address
Subnet mask
Default Gateway
If DHCP mode is enabled (IP auto configuration = DHCP), the KVM IP Console
Module will try to contact a DHCP server in the subnet to which it is physically
connected. If a DHCP server is found, it may provide a valid IP address, gateway
address and net mask. Before you connect the device to your local subnet, be sure to
complete the corresponding configuration of your DHCP server. It is recommended to
configure a fixed IP assignment to the MAC address of the KVM IP Console Module
unit. You can find the MAC address labeled on the bottom side of the metal housing.
KVM IP Console Module Setup Tool
If this initial configuration does not meet the local requirements, please use the setup tool to
discover KVM IP Console Module and change the configurations as user requested. The
setup tool IPSetup can be found in the CD delivered with KVM Switch (KVM-0831/1631 &
KCM-0831/1631). User can also download the setup tool from website at
Follow the procedures described below for using setup tool IPSetup.
■
DHCP
If you have installed the KVM IP Console Module unit on a network that enables
DHCP, you can use the IPSetup to find out the KVM IP Console Module unit's IP.
(1) Plug Ethernet cable to KVM IP Console Module unit. KVM IP Console Module
will get an IP via DHCP.
(2) Using IPSetup (run IPSetup.exe) to look for KVM IP Console Module.
a. Select MAC address which label on bottom of KVM IP Console Module unit
b. Click Query Device
192.168.1.22
255.255.255.0
None
6 / 87
KVM IP Console Module
www.level1.com