Table of Contents
Advertisement
KVM IP Console Module
3. Hardware installation
The KVM IP Console Module switch redirects local keyboard, mouse and video data to a
remote administration console. It allows you to control one or many computers locally at the
server site or remotely via the Internet using a standard browser. You can securely gain
BIOS level access to systems for maintenance, support, or failure recovery over the
Internet. Communication is secure via SSL encryption. Use in conjunction with a KVM
switch for multiple-server access.
3.1 Installation
The KVM IP Console Module works with the KVM Switch that has an expansion slot.
Ex) KVM-0831/1631, KCM-0831/1631
Below is a diagram illustrated KVM-0831 and ACC-2000
USB Port
Serial Port
Ethernet Port
Please perform the following steps:
1. (Optional) Connect the type A connector of USB A-B cable to the host computer, while
using remote mass storage control.
2. Connect Ethernet to LAN port and/or modem to serial port, depending on how you want
to access KVM IP Console Module switch
Please perform the following steps:
3. Power down computer and the KVM Switch
4. Remove the cover on the expansion slot from KVM Switch and carefully slide in the KVM
IP Console Module into the expansion slot.
5. Connect the power supply to the KVM Switch once IP Console Module firmly installed.
6. Connect the monitor, keyboard and mouse to the KVM Switch.
7. Use VGA cable (15-pin HDDB Male / Male) connects computer and KVM Switch.
13 / 87
Advertisement
Table of Contents
