Lexus RX350/270 Owner's Manual page 595

RX350_270_EE_48D77E.book 595 ページ ２０１４年１月２４日 金曜日 午前１０時４分
RX350
STEP 2
Connect the jumper cables according to the following procedure:
Connect a positive jumper cable clamp to the positive (+) battery
terminal on your vehicle.
Connect a positive jumper cable clamp to the positive (+) battery
terminal on the second vehicle.
Connect a negative cable clamp to the negative (-) battery terminal
on the second vehicle.
Connect the clamp at the other end of the negative cable to a solid,
stationary, unpainted metallic point away from the battery and any
moving parts, as shown in the illustration.
Start the engine of the second vehicle. Increase the engine
STEP 3
speed slightly and maintain that level for approximately 5 min-
utes to recharge the battery of your vehicle.
Open and close any of the doors with the "ENGINE START
STEP 4
STOP" switch off.
Maintain the engine speed of the second vehicle and start the
STEP 5
engine of your vehicle by turning the "ENGINE START STOP"
switch to IGNITION ON mode.
RX350/270_EE
5-2. Steps to take in an emergency
5
595