RX350_270_EE_48D77E.book 529 ページ 2014年1月24日 金曜日 午前10時4分
CAUTION
Replacing light bulbs
■
Turn off the lights. Do not attempt to replace the bulb immediately after turning
●
off the lights.
The bulbs become very hot and may cause burns.
Do not touch the glass portion of the light bulb with bare hands. When it is
●
unavoidable to hold the glass portion, use and hold with a clean dry cloth to avoid
getting moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
Fully install light bulbs and any parts used to secure them. Failure to do so may
●
result in heat damage, fire, or water entering the headlight unit. This may damage
the headlights or cause condensation to build up on the lens.
Metal components
RX350/270_EE
4-3. Do-it-yourself maintenance
Vehicles with discharge headlights:
●
While the low beam headlights are turned
on, and for a short time after they have
been turned off, metal components at the
rear of the headlight assembly will be
extremely hot. To prevent burns, do not
touch these metal components until you
are certain they have cooled down.
4
529