Section 1 Servicing Notes - Sony SA-WCT260H Service Manual

ADVANCE PREPARATION WHEN CONFIRMING OP-
ERATION
All of the units included in the HT-CT260H (SA-WCT260H/SA-
CT260H) are required to confi rming operation of SA-WCT260H.
Check in advance that you have all of the units.
SECTION 1
SERVICING NOTES
NOTE OF REPLACING THE WS R BOARD
When the WS R board is exchanged, you must perform linking
between SA-CT260H and SA-WCT260H.
Linking method:
This operation requires a remote commander.
You can link the Sound Bar (SA-CT260H)
and the subwoofer (SA-WCT260H) again
to enable wireless transmission between
them.
1
Press LINK on the rear of the
subwoofer with the point of a
pen, etc.
The subwoofer keeps beeping for
a certain time. Perform steps 2 to 5
before the subwoofer stops
beeping.
2
Press AMP MENU.
3
Select "WS" with
then press
4
Select "LINK," then press
5
"START" appears, then press
"SEARCH" appears, and the Sound
Bar searches for equipment that
can be used with Link. Proceed to
the next step within 1 minute.
To quit the Link function during a
search for equipment, press .
When subwoofer is linked with the
Sound Bar, the
the subwoofer lights up in green
and the subwoofer beeps once.
"OK" appears on the front panel
display.
If "FAILED" appears or the
subwoofer does not stop beeping,
perform the process again from
step 1.
6
Press AMP MENU.
The AMP menu turns off.
SA-WCT260H
AMP
MENU
(select),
.
.
.
indicator on
3