Note:
Auto Setup uses state-of-the-art signal processing algorithms based on the image
displayed on your screen. Therefore, you should not change the image on your screen
while Auto Setup is running.
Once you have executed Auto Setup for a particular mode, the monitor will store the new values in
its permanent memory.
To execute Auto Setup using the Direct Key function:
1. Make sure the OSD Main Menu is not displayed onscreen. Press the Down (
the AUTO SETUP (
2. After Auto Setup has finished, you should have a stable and clear image.
Adjusting Brightness Using the Direct Key
To adjust brightness directly:
1. Make sure the OSD Main Menu is not displayed onscreen. Press the Up (
the BRIGHTNESS (
▲
2. Press the Up (
3. Press the Select (
) submenu and start running Auto Setup.
) submenu.
▼
) or Down (
) buttons to increase or decrease the brightness setting.
) button to close and exit the BRIGHTNESS menu.
21
▼
) button to open
▲
) button to open