Installation Of Accessories - Baofeng MP25 Series Owner's Manual

• 2pin Kenwood headset jack
• Li-Ion 1500mAh battery pack
• Up to 5 km range*
*Range may vary depending on environmental and/or topographical conditions.

Installation of Accessories

Installing and Removing Belt Clips
With the belt clip, you can easily attach the radio to the belt. However, the belt clip must be removed to install or replace the
battery.
To remove the belt clip, follow the illustration. Fasten the clip into the slot on the unit in the radio's rear rail until it snaps
into the square.
Install the Li-ion Battery (BL-T22)
Each radio operates with either a Li-ion battery pack or optional 3 AA
alkaline batteries. The belt clip should be removed (see below) to
ease installation or removal of the batteries.
• Install
1) Remove the belt clip as described in the previous paragraph.
2) Insert the battery pack into the appropriate compartment of the
device.
3) Close the battery compartment with the cover and put the belt
clip back in place
• Remove
1) Remove the belt clip as previously described.
• Type-C USB connector for charging
• Keystroke Tones
• Battery Life: up to 18 hours (under typical use conditions)