Table of Contents
Advertisement
Design Notice
In order to ensure the optimal performance of our products, the design specifications
of the unit and remote control are subject to change without prior notice.
Ambient Temperature Range For Unit Operating
Exhaust Hose Installation
The exhaust hose and adaptor must be installed when operating in COOL mode. The
exhaust hose must be removed when operating in FAN or DRY modes.
Choosing The Right Location
Recommend Installation
50cm
19.7 inch
Mode
Cool
Dry
Your installation location should meet the following
requirements:
• Make sure that you install your unit on an even surface
to minimize noise and vibration.
• The unit must be installed near a grounded plug, and the
Collection Tray Drain (found on the back of the unit)
must be accessible.
•
The unit should be located at least 30cm (12inch) from
the nearest wall
horizontal louver blade should
(19.7inch) away from obstacles.
•
Do not cover the Intakes, outlets or remote signal
receptor of
unit.
Note:
All the illustrations in the manual are for explanation purpose
only. Your machine may be slightly different. The unit can be
controlled by the unit control panel alone or with the remote
control.
Note About Fluorinated Gases
This air-conditioning unit is a hermetically sealed unit that
•
contains fluorinated gasses. For specific information on the
type of gas and the amount, please refer to the relevant label
on the unit itself.
Service, maintenance and repair of this unit must be
•
performed by a certified technician.
Product recycling must be done according to local regulations.
•
Temperature Range
62°F ~ 95°F
(17°C ~ 35°C)
55°F ~ 95°F (13°C ~ 35°C)
to ensure proper air conditioning. The
be at least 50cm
the unit, as this could cause damage to the
Page 13
Advertisement
Table of Contents
