Advertisement
OptiXstar W826E
Quick Start
Mounting kits must be installed on the main keel.
1.
2.
1. Flat-edge T-shaped keel
mounting kit a
1.
2.
3.
Issue 01 (2021-09-07)
Partially tighten the M3X6.2 retaining screws into the T-shaped keel mounting
kit.
Install flat-edge T-keel mounting kits a and b along the sliding slots on the
mounting kit body in the sequence shown in the figure.
Route the M3X8 screws through the holes marked "24" in the figure, and
tighten the keel mounting kit a. If the T-shaped keel is 15 mm or 38 mm, it
corresponds to the "15" and "38" holes on the mounting bracket.
Clip the keel mount a into the T-keel and slide b inward along the slot until
the T-keel is clamped.
Route the M3X8 screws through the holes marked "24" in the figure, and
tighten the keel mounting kit b. Tighten the keel mounting stop screw
M3x6.2.
Copyright © Huawei Technologies Co., Ltd.
2. Flat-edge T-shaped keel mounting kit b
2 Installing the Device
6
Advertisement
