Advertisement
OptiXstar W826E
Quick Start
3.
4.
5.
Ensure that the device is properly installed on the mounting bracket to prevent it
from falling off. Ensure that the installation space meets the preceding
requirements for future maintenance.
Indoor T-shaped keel installation mode
The T-shaped keel must be able to withstand four times the total weight of the
equipment and sheet metal mounting kits without being damaged. When the
total weight of the equipment and sheet metal mounting kits is less than 1.25 kg,
the bearing capacity of the keel must be at least 50 N.
1.
Issue 01 (2021-09-07)
Place the sheet metal mounting kit against the wall, and then use a Phillips
screwdriver to tighten the three expansion screws into the expansion tube to
secure the sheet metal mounting kit to the wall.
Connect and arrange cables. For details, see 3.
Align the mounting pegs at the rear of the device with the mounting holes on
the sheet metal mounting bracket, push the device vertically into the
mounting bracket, and press the device downwards. If you hear a click, the
device is secured to the sheet metal mounting bracket.
Determine the type of the T-shaped keel. The following figure shows the
specifications of the T-shaped keel supported by the mounting kit. This
installation method uses a 24 mm flat T-shaped keel as an example.
Copyright © Huawei Technologies Co., Ltd.
2 Installing the Device
5
Advertisement
