Table of Contents
Advertisement
6.3
Ignition
Once the tank has been filled up, the stove is ready to be turned on.
CAUTION: always clean the brazier prior to each ignition to avoid false starts, if there is little ash residue,
clean it by means of the shaker; in case of hard-to-clean ash residue, take out the brazier and manually
shake it.
CAUTION: always carry out this operation with the stove switched off and cooled down. RISK OF BURNS.
Ignition procedure:
1 Put the loading lever in the "Go" position and lower it to the rest position (Fig.19). The pellets will
descend until the brazier is filled
2 Lift the pin located on the top of the stove using the starting lever provided and turn it to the locked
position (Fig 21-22)
CAUTION: Always remove the starting lever to avoid overheating
CAUTION: always carry out this operation with the stove switched off and cooled down. Risk of Burns
3 open the main door and position a solid or gel-like ignited on top of the pellets in the brazier and
light it using a flame
on the room temperature and on the chimney flue). Close the door only when the flame reaches a
minimum height of about 3 inches, so as to lick the holes located in the rear wall
INSERT
PELLET
Fig. 13
Fig. 21
leave the door ajar for a couple of minutes or even longer (this depends
(fig.23);
Fig.22
Fig. 23
17
B
CLOSED
Fig. 14
Advertisement
Table of Contents
