Advertisement
Quick Links
ASSEMBLY INSTRUCTIONS:
7200-5005 METAL BED QUEEN 5/0
Thank you for purchasing this quality product. Before beginning, please check the packing material carefully
for small parts which may have come loose inside the carton during shipping. Please do not discard any
packing material until all parts have been located. If any parts are missing, please contact your dealer for
prompt replacement.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture
for stain residue and rough surfaces and also check for staples or nails left after removing the packaging
material. The manufacturer will not be held responsible if preventative steps are not taken prior to
installation.
(3) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They
should be periodically inspected and re-tightened to prevent damage to the furniture and (or) personal
property or cause injury. Always check to be sure all hardware on this list and the below mentioned
components are attached to the furniture properly and kept tightened.
Parts & Hardware List:
PARTS LIST
A
HEADBOARD
B
FOOTBOARD
C
BED RAIL
D
CANOPY RAIL
CANOPY CENTER
E
F
SLAT RAIL
G
SUPPORT LEG
H
FINIAL
I
HEADBOARD POST
J
FOOTBOARD POST
D
D
E
Step 2
Q'TY
1 PC
1 PC
2 PCS
4 PCS
1 PC
3 PCS
3 PCS
4 PCS
2 PCS
2 PCS
8
9
D
D
www.legacyclassic.com
LEGACY CLASSIC
HARDWARE LIST
1
LONG BOLT
LARGER LOCK
2
WASHER
LARGER FLAT
3
WASHER
LARGE HEX
4
WRENCH
5
SHORT BOLT
SMALL LOCK
6
WASHER
SMALL FLAT
7
WASHER
SMALL HEX
8
WRENCH
9
NICKEL BOLT
A
C
Step 3
FURNITURE
Q'TY
8 PCS
5/16"*25mm
8 PCS
5/16"
8 PCS
5/16"*19*2mm
1 PC
70*30*5mm
6 PCS
1/4"*15mm
6 PCS
1/4"
6 PCS
1/4"
1 PC
70*30*4mm
8 PCS
1/4"*15mm
3
1
2
4
C
B
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Legacy Classic Furniture 7200-5005
Summary of Contents for Legacy Classic Furniture 7200-5005
- Page 1 ASSEMBLY INSTRUCTIONS: LEGACY CLASSIC 7200-5005 METAL BED QUEEN 5/0 FURNITURE Thank you for purchasing this quality product. Before beginning, please check the packing material carefully for small parts which may have come loose inside the carton during shipping. Please do not discard any packing material until all parts have been located.
- Page 2 ASSEMBLY INSTRUCTIONS: LEGACY CLASSIC 7200-5005 METAL BED QUEEN 5/0 FURNITURE Step 4 Step 5 Assembly Procedures: Step 1: Lay out all parts and hardware. Make sure the quantity of each is correct and the feet are free of stain, staples, screws and nails.
Need help?
Do you have a question about the 7200-5005 and is the answer not in the manual?
Questions and answers