Summary of Contents for Blue Sky Network SKYLINK 7100
Page 1
SKYLINK 7100 Installation Guide Email: support@blueskynetwork.com Blue Sky Network, LLC Website: www.blueskynetwork.com 5353 Mission Center Rd, Suite 222 San Diego, CA 92108...
SkyLink 7100 Installation Guide v1.0 NOTICE This guide is published and copyrighted by Blue Sky Network (BSN). All information and specifications in this document are subject to change without notice. Nothing in this document is intended to create additional or separate warranties or guarantees.
& control. It is IP65 Certified and FCC Part 15 & 25 Certified. SkyLink Cloud Services is a performance-driven, cloud-based analytics platform for remote, mobile, and global operations. With SkyLink 7100 and SkyLink Cloud Services, achieve total connectivity for all assets, in every location, across the globe.
Environmental Qualification The SkyLink 7100 terminal is tested and qualified to D0160G sections 4-12, 15-21, and 25. The Iridium-approved, single channel antenna is tested and qualified to DO160G sections 4-8, 10-14, 23, 24, and 26. It is also TSO’d to TSO C159d.
The SkyLink 7100 has no licensing requirements. Cooling Air Requirements The SkyLink 7100 has very low power usage, so forced air cooling is not required for any of the components. However, terminals should be kept away from heat sources. Aircraft Interfaces The SkyLink 7100 operates independent of aircraft navigation systems.
RS232 – RTS Power Input The only component of the SkyLink 7100 requiring aircraft power is the terminal. The SkyLink 7100 power interface supports wide voltage input in the range of 10 – 34 VDC. The following input connections are the most commonly used: 28 VDC nominal, typically less than 0.5A...
• AC43.13-2A. Damage caused by improper installation will void product warranty. To ensure optimal performance, the SkyLink 7100 and associated wiring should be kept a • minimum of 3 ft. from high noise sources and not routed with cables from high power sources.
SINGLE-CHANNEL IRIDIUM ANTENNA NOTE: A Certus-certified antenna for SkyLink is required. Antenna installation should be completed prior to installing the SkyLink 7100. The antenna must be installed on top of the aircraft fuselage, away from the vertical stabilizer and with an unrestricted view of the sky down to 8 degrees above the horizon (similar to a GNSS antenna).
EQUIPMENT SETUP Step 1 – Install Cellular & Iridium SIM Cards NOTE: If you purchased your SkyLink device through Blue Sky Network, the unit will come with cellular and Iridium SIM cards already installed. To install your cellular and Iridium SIM cards: 1.
IRIDIUM ANTENNA The SkyLink 7100 device utilizes a single-channel Iridium antenna with remote connection to the unit. Use the Iridium antenna connector located on the top panel (“IRI” will be etched into the connector’s recess).
FXO adapter to connect a phone system. RS232 Adapter • NOTE: The RS232 cables are proprietary and available only from Blue Sky Network. The SkyLink RS232 cable kit comes with a DB9F connector and conforms to the RS232 standard pinout for a DB9. Please contact sales@blueskynetwork.com...
1) Connect the power cable into the power port and the adapter into the appropriate power source. 2) Observe the LEDs. When power is first applied to the SkyLink 7100, the light will show green, red, then flashing blue as it boots. A steady blue LED indicates that the unit is ready to use.
Quotation. Product Terms and Conditions Blue Sky Network, LLC (“Blue Sky”) warrants that the Products it manufactured shall be free from defects in materials and workmanship. This warranty (i) shall apply to Customer (as named in the Quotation) only and no other and (ii) shall not apply to any Product which is not stored, handled, installed, or used in strict accordance with Blue Sky’s specifications and instruction manuals, or...
SkyLink Installation Guide v2.8 APPENDIX A - TROUBLESHOOTING If you are unable to activate your SkyLink device, please contact the Blue Sky Network support team and we will be happy to help! 1) Check to ensure the antennas on your device are functioning and attached to the appropriate connectors located on the top panel.
SkyLink 7100 Installation Guide v1.0 SUPPORT Blue Sky Network is committed to providing the highest level of service and support. If you have any questions or concerns, please feel free to contact us by email or phone; contact information is available at the bottom of this page.
Need help?
Do you have a question about the SKYLINK 7100 and is the answer not in the manual?
Questions and answers