Table of Contents
Advertisement
IMPORTANT:
R
EMOVAL OF PROTECTIVE FILMS CAN PRODUCE ELECTRIC SHOCKS AND SPARKS WHICH COULD CAUSE
DAMAGE TO CONNECTED ELECTRONICS
A
LL PROTECTIVE FILMS MUST BE REMOVED
WD‐02.1.4 Dry Contact Connections
The WD‐02.1.4 has been designed to accommodate many installation configurations and scenarios by utilizing a
flexible Dry Contact Input Circuit. This circuit allows a wide variety of switch devices, relays, or other automation
controllers to provide end user control of the CLiC Glass panel. The triggering device shall use a ground referenced
switch or relay type output. There shall be no power applied directly to the Dry Contact connections. These devices
can include, but are not limited to:
Standard light switches
Occupancy Sensors
Relays and Switch outputs from automation controllers or remote‐control systems
Doorjamb Plunger Switches
Magnetic Security Style Door Switches
!
PRIOR
TO CONNECTION OF THE GLASS CONTROLLER
N
:
U
‐
OTE
SED FOR LOW
VOLTAGE TRIGGER
!
ONLY
NOT
AND
CONNECTED TO POWER
Page 10 of 14
Rev. A
Advertisement
Table of Contents
