Fiat 500 Manual page 69

–
press the + or
presses) to select the new setting;
briefly press the MENU button
store the new setting and to go back to
the same main menu option selected
previously.
Selecting an option from the main
menu with a submenu:
briefly press the MENU button
display the first submenu option;
–
press the + or
presses) to scroll through all the
submenu items;
briefly press the MENU button
select the displayed submenu option
and to open the relevant setup menu;
–
press the + or
presses) to select the new setting for
this submenu option;
a short press on MENU button
will store the setting and then return to
the same submenu option that was first
selected.
Note With Uconnect™ system (for
versions/markets where provided),
some Menu items are shown and
managed on the display of the latter
and not on the instrument panel display
(refer to the Uconnect™supplement).
Menu
This option allows you to access the
Setup Menu.
–
Press the + or button to select the
various Menu options.
60
buttons (with single Hold down the
return to the standard screen.
to
Dimmer (Car interior lighting
adjustment)
On some versions, the instrument
panel is provided with a light sensor
capable of detecting environmental
light conditions and adjusting the
to
brightness of the instruments
accordingly.
buttons (with single
The brightness of the instrument panel
may therefore change while driving
following an event causing a switch
to
from "day" to "night" conditions (or vice
versa) in the passenger compartment
(e.g. in a tunnel, on avenues in
buttons (with single
shadows, under flyovers, etc.).
The lighting can be adjusted in
night mode only with dipped beam
headlights on. If the headlights are not
on, it can be adjusted in day mode.
This function is available, with the
dipped headlights on and in night-time
conditions, to adjust the brightness of
the instrument panel, control buttons,
sound system display and automatic
climate control display.
On some versions, during the daytime
and with dipped headlights on, the
instrument panel, control buttons,
sound system and automatic climate
control displays are set to maximum
brightness.
MENU button to Proceed as follows to adjust the light
intensity:
press the MENU button
to make the display flash the previously
stored level;
press the + or
brightness level;
press the MENU button
return to the menu screen or hold the
button down to return to the standard
screen without storing.
Speed beep (Speed limit)
This function is used to set the car
speed limit (km/h or mph); the driver
is immediately alerted when this limit is
exceeded (see section "Warning lights
and messages").
To set the desired speed limit, proceed
as follows:
briefly press the MENU button
the display will show the words (Speed
Beep);
press the + or button to select
speed limit activation ("On") or
deactivation ("Off");
if the function is enabled (On), press
the + or
speed limit and press the MENU button
Note The speed may be set anywhere
between 30 and 200 km/h or 20 and
125 mph, depending on the previously
chosen unit (see the "Setting the unit
of measurement (Unit)" paragraph).
briefly
–
button to adjust the
briefly to
–
button to select the required
to confirm.
: