Steering Wheel; Rear-View Mirrors - Fiat 500 Manual

21
The particular shape of the head
restraint deliberately interferes with the
correct support of the rear passenger's
back on the backrest in order to force
them to lift the head restraint for correct
use.
WARNING If the rear seats are used,
always set the head restraints in the
"completely raised" position.
Removal
To remove the rear head restraints
press buttons (A) fig. 21 and (B) at the
side of the two supports simultaneously
and lift them out upwards. The rear
head restraints must be lifted out with
the backrest released and tilted toward
the passenger compartment or with the
tailgate open.
WARNING
12) All adjustments must be carried out
only with the car stationary and engine off.
Head restraints must be adjusted so that
the head, rather than the neck, rests on
them. Only in this case they can protect
your head correctly.
13) To make the best use of the head
restraint's protective action, adjust the
backrest so that you are sitting upright and
F0S0034
keep your head as close as possible to the
head restraint.

STEERING WHEEL

14) 15)
The steering wheel can be adjusted
vertically.
To adjust bring the lever (A) fig. 22
downward in position (2), then adjust
the steering wheel to the most suitable
position and lock it in this position
bringing the lever (A) in position (1).
22
WARNING
14) All adjustments must be carried out
only with the car stationary and engine off.
15) It is absolutely forbidden to carry
out any after-market operation involving
steering system or steering column
modifications (e.g.: installation of
anti-theft device) that could badly affect
performance and safety, invalidate
the warranty and also result in non-
compliance of the car with type-approval
requirements.
REAR-VIEW
MIRRORS
INTERIOR MIRROR
The mirror is fitted with a safety device
that causes its release in the event of a
violent impact with the passenger.
Lever (A) fig. 23 can be used to move
the mirror to two different positions:
normal or anti-glare.
F0S0567
23
F0S0019
21