Factory Setting - Conrad Electronic FS20 PIRI-2 Operating Instructions Manual

7. Factory setting

The 'FS20 PIRI-2' is immediately ready for use and configured with the following factory default
settings:
• Channel 1 activated (ON)
• Activation also in lighted areas (dawn/dusk switch function inactive)
• Receiver on-time triggered by movement in front of the detector: 1 minute, then load is
switched off (transmit command).
• If further movements are registered during this minute, a new power-on command will be
transmitted, at most every 24 seconds, thereby restarting the 1-minute on-time (transmis-
sion interval).
• Channel 2 is inactive (OFF).

The terms printed here in bold are the adjustment criteria for each channel,
whose programming is described separately in the following user manual.
9